Rinnai RHFE-1004FA Owners & Installation Manual page 4

Overcurrent Prevention Device:
Power Outaqe Safety Device:
This is a 5 amp. glass fuse found on P.C. board. Design to
shut unit down in case of overcurrent. If fuse blows all
indicator lamps will be "OFF".
This safety device cuts off gas passage and stops
operation.
Local and state codes must be adhered to prior to installation.
Rinnai is continually updating and improving products therefore specifications are subject to change
without prior notice.
NAT, LPG
Minimum supply gas pressure 5.0" (127mmH20) 11.0" (279mmH20)
Maximum supply gas pressure 10.5" (267mmH20) 13.0" (330mmH20)
Manifold test pressure Factory set Factory set
•_See conversion for setting gas pressures.
•There's 1/8" NPT pipe tap provided for gas pressure test. That is located on the gas control assembly A.
The minimum inlet gas supply pressure is for the purpose of input adjustment.
f
GENERAL INFORMATION
THIS SERIES IS DESIGN CERTIFIED BY THE AMERICAN GAS
ASSOCIATION LABORATORIES (AGA) AND INTERNATIONAL
APPROVAL SERVICES (IAS).
ALTERATION OF THE ORIGINAL DESIGN INSTALLED OTHER
THAN AS SHOWN IN THESE INSTRUCTIONS OR USED WITH
A TYPE OF GAS NOT SHOWN ON THE RATING PLATE, IS
THE RESPONSIBILITY OF THE PERSON AND COMPANY
MARKING THE CHANGE.
Thank you for purchasing a Rinnai gas forced flue heater.
Before using this product, please read this manual carefully to insure proper use of the product.
Please read the attached warranty thoroughly and keep it in a safe place.
-2-