Fitting The Radio Control - Vaillant VRT 350f Installation Manual

3. Insert a screwdriver into the slot (7) on the wall base
(2).
4. Carefully lever the radio receiver unit (1) from the wall
base (2).
5. Mark a suitable position on the wall. Take the eBUS
line cable laying into account when doing so.
6. Drill two holes in line with the mounting holes (3).
–
Diameter of mounting hole: 6 mm
7. Route the eBUS line through one of the grommets (4).
8. Insert the wall plugs supplied.
9. Use the screws supplied to secure the wall base.
10. Connect the eBUS line to the terminal block.
(→ Page 13)
11. Carefully insert the radio receiver unit in the wall base.
Ensure that the pin header connector (5) on the wall
base fits into the radio receiver unit plug-in connection
provided.
12. Carefully press the radio receiver unit into the wall base
until the locking tabs on the radio receiver unit are
heard to click into place.
4.4

Fitting the radio control

1. Fit the control on an internal wall of the main living
room in such a way that ensures that there are no prob-
lems with the radio link between the control and the ra-
dio receiver unit.
– Height: ≈ 1.5 m
0020131978_02 Installation instructions
1 Unit mounting bracket
2 Mounting openings
2. Remove the unit mounting bracket from the rear of the
control by pulling the bracket downwards.
3. Remove the finishing panel from the unit mounting
bracket by pulling the top edge of the panel away from
the unit mounting bracket with your fingers.
4. Mark a suitable position on the wall.
5. Drill two holes in line with the mounting holes (2).
–
Diameter of mounting hole: 6 mm
6. Insert the wall plugs supplied.
1
2
3
3 Finishing panel
11