Advertisement
CONNECTIONS
PD-202/102
~ Power cord
Control cord
'Output cable
D-DECK SYNCHRO cord
@
Make sure that all of the components are turned off before
making connections,
CONNECTING THE OUTPUT CABLE:
Connect the LINE OUT jacks of this unit to the input jacks (CD or
AUX) of the amplifier. Make sure that the white phugs are connected
to the left (L) jacks and the red plugs to the right (R) jacks
@
Be sure not to connect this unit to the amplitier's PHONO jacks,
as sound will be distorted and normal playback will not be
passible.
CD-Deck synchro function
If you have a Pioneer cassette deck provided with the CD-Deck
synchro function, connect the CD*DECK SYNCHRO jacks of the
CD player and cassette deck.
With this function, synchro
recording can be carried out between player and deck.
@
For details on connections and operation, refer to the Operating
Instructions supplied with the cassette deck
@
The CD-DECK
SYNCHRO
cord is not supplied with the CD
player.
MOTE:
In order to enable the CD-DECK
SYNCHRO recording function, the
normal output cable must be connected to the stereo amplifier.
System remote control with a Pioneer stereo
amplifier that has the (jj mark
(Available with the PD-102 (except for Singapore and multi-voltage
madels) and U.S, and Canadian models of the PD-202 only: Not
available with models for military zones (multi-voltage types))
When
a Pioneer stereo amplifier bearing the
mark is used,
connect the CONTROL IN jack on the rear panel of the CD player
to the CONTROL OUT jack of the amplifier. This will enable the CD
player to be controlled using the remote control unit supplied with
the stereo amplifier. if you do not plan to use this feature, itis not
necessary to connect CONTROL IN/OUT jacks.
@
The control cord is supplied with the CD player.
®
The remote control unit supplied with the amplifier can be used
to control Play, Stop, Pause and Track Search.
@
For instructions regarding connections and operation, reter to
the Operating Instructions provided with your stereo amplifier.
NOTES:
e@ When a control cord is connected to the player's CONTROL
IN jack, direct contro! of the player with the remote control
unit is not possible.
Operate the player with the remote
control unit by aiming it at the amplifier. (PD-202)
e@ Be sure to connect both of the contro! cord's plugs securely
to the CONTROL. IN and CONTROL
OUT terminals. Do not
connect only one end of the cable.
e@ Be sure to turn off the power of the amplifier when connecting
the power cord and output cord.
CONNECTING THE POWER CORD:
Connect the power cord to a household AC wall outlet er an AC
outletonyour amplifier. (See the section "AC power cord connection
and functions" on page 4.)
@
Make sure plugs are inserted fully into the jacks and wall outlet.
TIMER PLAYBACK
By using a commercially available audio timer, itis possible to initiate
playback at any time automatically.
1. Turn on the power to the player, load a disc into the disc tray
and close the disc tray with OPEN/CLOSE.
.
2. Set the time at which you wish playback to begin.
The timer
will supply power to both the amplifier and the player at the
preset time, turning all the components on and initiating the'
playback mode. Playback starts from the first track.
NOTES:
e@ {f no disc has been loaded in the player, the player will enter the
standby mode when the audio timer turns the player's power on.
e@ Pressing any function buttons before commencement of timer
start cancels the timer start function.
5
<PRB1182>
En
Advertisement
