Advertisement
CONVENIENT OPERATION FOR RECORDING
2 Designate the length of tape to be used.
When the digit buttons are used:
Press the digit buttons to set the length (time} of the tepe.
Press the 10's digit button and 1's digit button sequentially. (To
enter 9 minutes or less, press [10] and then the corresponding
digit button.)
When the track search buttons are used:
Press jaded <a (Or tt) OF b> BB (Or Bi) to set the length (time)
of the tape.
@
Each time the buttons are pressed, the time setting will change
in the following order:
4G a>
54 +--+ 60 «> 74 ++ 90
.
_
C
Unit: Minute
@
The displayed time is memorized
and the player starts
calculation by pressing COMPU/AUTO EDIT or if other time
setting is not selected within 3 seconds.
Example: The tape playing time 46 minutes is selected.
COMPU PROGRAM EDIT
AUTO PROGRAM EDIT
Side A
tbe dene see
hice
Le
used.
dealer to carry out repair work,
To confirm the programmed results:
After completion of programming,
press COMPU/AUTO
EDIT;
gach time the button is pressed, the program
results will be
alternately displayed for tape side A and B
NOTES:
e@
Upto 24 steps can be programmed.
@
With discs contained 24 tracks of more, programming may
not be correctly performed.
e
ff the selected
time
is too short
for any
track
to be
programmed, programming cannot be performed.
e@ /f you wish to enter the time with the digit buttons after the
time is already entered with t@ <4 (or t<¢<4} OF Pe Bl
(or
Pi) in step 2, press
|>10].
The digit buttons can now be
operated.
®
[f the disc is in the player, the contents of the Compu program
edit are not cleared even when the power is turned off.
However, if the power is turned off with an audio timer or by
unplugging the power cord,
the program
contents
will be
erased,
Symptom
Cause
Dise tray is not expelled when OPEN/
CLOSE is pressed.
® Power plug is disconnected from outlet.
@ The POWER switch is OFF (STANDBY).
| @ Connect plug to amplifier or wall outlet.
@
Press the POWER switch ON.
When playback is started, it stops | e
Disc is loaded upside down.
Load the disc correctly with the label side UP.
immediately. Pauses or stops during | # Smudges etc., on the disc.
e Clean the smudges from the disc and then play
playback.
it again
connect to PHONO terminals.
®
Pin plugs and/or amplifier terminals are dirty. | @
Clean away dirt.
®
interference is being picked up from a TV | @
Switch OFF TV set, or move player away from
set.
TY set
14
<PRBI182>
En
Advertisement
