Advertisement
Available languages
Available languages
EN
TROUBLESHOOTING
WARNING: TO REDUCE THE RISK OF INJURY
FROM MOVING PARTS AND/OR ELECTRICAL
SHOCK, TURN POWER SWITCH OFF AND
DISCONNECT GROUNDED PLUG FROM
ELECTRICAL OUTLET BEFORE PERFORMING
TROUBLESHOOTING CHECKS.
Minor problems often can be fixed without calling
customer service.
PROBLEM
Check power cord, plugs and outlet.
Motor does not
Ensure the on/off switch is in the
run.
ON position ( I ).
Remove blockages in the floor nozzle,
extension wands, hose or filter.
Replace the disposable dust bag.
Check for proper installation of the
Suction capacity
filter.
decreases.
Clean or replace the filter.
Empty dust tank, refer to TO EMPTY
THE TANK under OPERATING
INSTRUCTIONS.
Thermal overload has been tripped:
1. Turn the vacuum off and disconnect
vacuum cleaner from power source.
Vacuum stops
2. Empty the dust tank, if needed.
running.
3. Allow the unit to cool.
4. Plug the power cord into an
appropriate outlet and turn on/off
switch to the ON position ( I ) to test.
Check for proper installation of the
filter.
Ensure filters are not damaged;
Dust comes out
replace if necessary.
while vacuuming.
Ensure filter seals are in place and
are secure.
Check the fit of the vacuum head.
WARNING:
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or a similarly
qualified person in order to avoid a hazard.
WARNING:
This product is NOT to be used for filtering of
pathogens, for example COVID-19. Follow all local,
state and federal guidance on general cleaning
practices.
SOLUTION
11
Advertisement
