Advertisement
E FRONT PANEL
@ POWER switch
Turn the power on and off. When the power is turned
on, the last program before the power has been
turned off is automatically recalled
"For several seconds after the power is turned on, the
sound is muted by the protection circuit.
® MIX INPUT jacks (MONO, L, R)
Used to mix the sound signal with the input source
from the INF'UT jacks on the rear panel. Use MONO
when the output terminal of the equipment to be
connected is monaural, and connect L and R jacks
when the equipment is stereo.
If both the MONO and L/R jacks are used
simultaneously, the level from the MONO jacks may
be lowered.
@ MIX INPUT LEVEL control
Used to adjust the input level from the MIX INPUT jacks.
Turning it clockwise increase the input signal level.
@ TAPE selector
7
Selects the input source or the signal recording
playback with the tape deck connected to this unit.
According to the knob position, the signal path
changes as follows:
è NORM: Sound field effect or special sound effect
can be applied to the input source from the rear
panel INPUT jacks or the front pane! MIX INPUT
jacks.
|
13
Input jacks
INPUT
e S )
FRONT
—4
MIX INPUT
Digital signai
PROCESSING
processing circuil |
—
|
p>
CY REAR
TAPE PB
REC OUT
Output jacks
MAIN/"MONO
| Signal path in the DSP-1
|
® MONITOR: Sound field effect or special sound
effect can be applied to the signal from the tape
deck connected to this unit
Signal path in the DSP-1
Output jacks
INPUT
MAIN/MONO
;
FRONT—4
MIX INPUT
Es dere chao
PROCESSING
pi
g
REAR —
TAPE
;
TAPE PB
REC OUT
è EFFECT REC: The effected sound (that the sound
field effect or special sound effect is applied to the
input source from the INPUT or M!X INPUT jacks)
can be recorded onto the tape deck. This signal is
output only from the REC OUT jacks.
Input jacks
Signal path in the DSP-1
INPUT
a
Digita) signai
A
processing circuit a +
Output Jacks
MAIN/MONO
© FRONT
MIX INPUT
PROCESSING
EAR ——!
TAPE PB
REC OUT
@ TAPE PB LEVEL control
Used to adjust the tape sound level input from the
TAPE PB jacks on the rear panel. -
@ Remote sensor
Receives the remote control infrared signal from the
remote control tramsmitter.
@ MUTE indicators (MAIN, EFFECT)
Lights when the MUTE key on the remote control
transmitter is pressed to mute the sound.
® MAIN: Lights when the MAIN MUTE key is
pressed to mute the source sound.
@ EFFECT: Lights when the EFFECT MUTE key is
pressed to mute the effect sound.
@ MODE indicators
These show the current mode; ACOUSTIC,
SURROUND, EFFECTOR or USER PROG mode.
© PROGRAM NO. display
Displays the selected program number.
@ PROGRAM
display
Displays the selected program name, parameter, etc.
* The display panel may not be understandable when
viewed from the certain direction. See it from the
front when operating.
|
Advertisement
