Advertisement
E TAPE DECK CONNECTION
A tape deck can be connected to the TAPE jacks of
the integrated amplifier or receiver (or control
this unit to record/play the source of effect sound..
amplifier), connect the tape deck to these jacks as
Also when this unit is connected to the tape jacks of
shown below.
Tape deck
LINE OUT!
LINE IN
Polarity indication:
s
i
,
The polarity indication
DSP-1 rear panel
TAPE PB}
TRECOUT
"
is to align the polarity
S
T
|
PARE
of your audio system.
@ YAMAHA
cm 5
bii
Pera h
T
nURTAG
4 tae ot iy
mat
PEROS
d
) SED,
O
Q
a
IA A
Up to 200W can be supplied to other equipment.
-
The supply is not controlled by the DSP-1's
POWER switch
.
Center speaker
11
El CONNECTION OF OTHER EQUIPMENT
_%& Connection of synthesizer or keyboard, etc.
(MIX INPUT jacks)
Stereo inputs (L, R) and mono input (MONO) are
provided for variety of use.
*To connect a microphone, a microphone amplifier
is required.
* Connection of the center speaker (MONO OUT
terminals)
The MONO OUT terminals which output the L-ch
+ R-ch mix signal are provided. Use the LOW
PASS terminal when adding the subwoofer to
compensate the very low frequency sound. Use the
FULL BAND terminal when adding the center
speaker between the left and right speakers to fill
up the localization of the sound image.
%* The AC outlet supplies the AC power (200W max.)
to the other audio component. This AC outlet is not
interlocked with the POWER switch of this unit.
Advertisement
