Table of Contents
Advertisement
Quick Guide
1
Charge the Battery. (- 12)
Connect the AC Cable to the AC Adaptor and AC Jack.
@ Attach the Battery to the AC Adaptor. (This will start charging.)
ch
@ When the Charge Lamp [CHARGE] goes off, the Battery is fully
iS
charged.
=
Since the Battery will not be charged when the DC Cable is connected
j
to the AC Adaptor, disconnect it.
|
2
Attach the Charged Battery to the Palmcorder. (+ 12)
® Attach the battery after tilting the Viewfinder upward.
3
Turn the Palmcorder on. (+ 14)
@Slide the 1] Switch to [ON]. (The [CAMERA] Lamp lights up.)
4
Insert the Cassette. (- 13)
@ Slide the 2] lever to the right and pull down to open the Cassette
compartment cover.
# Insert the Cassette.
:
e Press the [PUSH/TO CLOSE} 3] to load the Cassette.
® Close the lower compartment Cover.
VEUALIS! 7} > beans eect
5
Start recording. (- 20)
e Press the 4) Button. (Recording starts.)
_ @Press the €) Button again to pause the recording.
+
To watch the Playback Picture.
6
Switch to the VCR Mode, rewind the tape, and play the tape
back. (+ 28)
-
@ Slide the @ Switch. (The [VCR] Lamp lights up.)
Press the @ Button.
Press the @® Button. (This will start playback.)
7 Turn the Palmcorder off. (> 14)
Set the @ Switch to [OFF].
Advertisement
Table of Contents
