JVC XT-G70RBK Service Manual page 8

(68707 ON) 8-L
Features Guide
Playing Tapes
If there are 4-second or longer blanks between tracks on recorded tapes, you can use Music Scan to find the beginning of a track.
For simple playback procedures, see page 7.
Current Song
—— >
deck A c> | ~ [ deck 8 < |
deck A<J > [ deck 8 > |
Music Scan (Finding Songs)
To find the beginning of a music track use Music Scan. Music Scan searches for blank portions
that usually separates tracks, then plays the next track.
Finding the Beginning of the Current Song
Press the «#4 or >> button during play.
Make sure you press the «#4 or ® button in the opposite direction to tape play.
Searching stops automatically at the beginning of the current track, and the current track starts
automatically.
Finding the Beginning of the Next Song
Press the <4 or ®& button during play.
Make sure you press the «#¢ or > button in the same direction as tape play.
Searching stops automatically at the beginning of the next track, and the next track starts
automatically.
Notes
+ Music Scan works by detecting a 4-second blank at the beginning of each selection, so it won't
work well if your tape has:
— No blank at the beginning of a track.
~ Noise (often caused by much used or poor quality dubbing) which fills the blank with.
— Long very soft passages or pauses in a track. Music Scan will detect these instead of the 4-
second blanks.
« Music Scan only works on one tape at a time.
~ Ifyou use Music Scan on deck A during recording on deck B, deck B enters recording pause
mode.
— Ifyou start recording on deck B while Music Scan is used on deck A, Music Scan is stopped.
Using the REVERSE MODE Selector
When you play tapes, you can select the side to be played by using the REVERSE MODE selector.
x : only one side is played
2D _: both sides are played
<> : both sides are played repeatedly.
When tapes are in both decks, continuous play follows the sequence diagramed at the
left regardless where playback starts.
The sequence is repeated endlessly.
Page 10
Page IE
DOLBY NA
FOB
Skipping Blank Portions during Playback
If there is a blank portion of 10 seconds or longer on a tape, the Unit will automatically fast
forward, and skip the blank portion, then play back the next track.
Press the BLANK SKIP button before or during play.
The LED next to it lights up.
To cancel the blank skip playback
Press the BLANK SKIP button again.
The LED next to it goes off.
Using the DOLBY NR * Selector
To play a tape recorded with Dolby NR, set the DOLBY NR selector to the same NR system (B
or C) as was used when recording.
To play a tape recorded without Dolby NR, set the DOLBY NR selector to the OFF position.
If a tape is recorded with the Dolby NR system, playing it back with the same Dolby NR system
will reduce tape hiss and improve the clarity of the sound.
* Dolby noise reduction manufactured under license from Dolby Laboratories Licensing
Corporation,
"DOLBY" and the double-D symbol are trademarks of Dolby Laboratories Licensing
Corporation.
MaWO D-LX