Table of Contents
Advertisement
INSTALLATION
E Attaching the Divided Pickup with Screws
You can also use screws to secure the Divided Pickup. Marking the position of the Pickup and
checking the height is exactly the same as in "a. Attaching the Divided Pickup with double-sided
tape". Refer to that section before proceeding.
+
When attaching the Divided Pickup with screws, you need a 13 mm space between the body of the guitar and
the strings.
1. Place the Divided Pickup in the
5. Put the strings back on the guitar and tune
appropriate position. Carefully mark the
them properly.
location of the screw holes (at either end of
the Picl
tl
itar.
E RESAD SAINE KULLAR
6. Adjust the height of the Pickup.
Adjust the height of the Pickup by loosening
or tightening the screws. Use the clearance
gauge to set the proper Pickup height.
2. Remove the strings from the guitar.
3. Very carefully drill holes at the marked
* Afterwards, you will need to adjust the Pickup
locations.
sensitivity on the [GR]. If the signal level from
* The holes should be about 2 mim (0.08") in
the Divided Pickup is too high, lower the Pickup
i
.
olio
diameter and approximately 2 to 3 mm deep.
slightly.
* Ifthe guitar is made of a hard wood (maple, rock
maple, cherry, rosewood, ete.), make the holes
slightly larger than 2 min.
4. Place the supplied springs on the screws
between the bottom of the Pickup and the
guitar. Then tighten the screws:
17
Advertisement
Table of Contents
