CHANGING THE PAPER SIZE_
CHANGING THE PAPER SIZE
Paper sizes that this machine accepts are grouped into 3 categories - Stan¬
dard, Special, and Irregular sizes.
If you do not tell the machine the correct paper size, misfeeds may occur.
The outline procedure for changing the paper size is as follows:
A) Adjust the paper guides in the paper tray and load your paper.
B) Tell the machine the new paper size.
•
For standard sizes (these printed on the paper size selector), you only need
to adjust the paper size selector to the new size.
• For other sizes, adjust the paper size selector to
and specify the paper
size with the
[Special]
or
[Irreg.]
key.
For more information on paper size, => See page 22.
The next section will take you through this procedure step by step.
Changing The Paper Size For Paper Tray 1
D
Make sure that paper tray 1 is
not feeding paper for a copy or
print run, and pull out the tray
until it stops.
□ Remove any remaining paper.
Lower the bottom plate.
Square the paper and set it in
the tray.
□ Do not stack the paper over the
limit mark.
□ Shuffle the paper before setting
it in the tray.
40