Overhang; Child Restraint Functions; Harness/Head Restraint Height Adjuster - Britax Poplar Canadian User Manual

Overhang

It is important that the base of the child restraint
rests completely flat on the vehicle seat with no side
overhang. As seen in the illustration, it is permissible to
allow up to 7.5 cm (3 in) of the base to hang over the
front edge of the vehicle seat. If the vehicle seat does
not allow enough of the child restraint base to make
contact, adjust the recline angle to a more upright
position. Not doing so could cause the child restraint
to not perform as intended.
IMPORTANT:
seat and MUST be parallel to vehicle seat.
Acceptable
Forward-Facing

Child Restraint Functions

Harness/Head Restraint Height Adjuster

Adjusting Head Restraint and Harness Positions
Loosen the harness.
1.
a. Lift harness release
button.
b. Pull both harness
straps forward.
2. Squeeze the harness
height adjuster, slide
the harness into the
desired position and
release.
3. Gently pull head
restraint on each side
to ensure it has locked
into position.
12
Car seat base MUST be flat on vehicle
7.5 cm
Acceptable
Rear-Facing
1
2
3
7.5 cm