Overhang; Adjusting Buckle Position - Britax GROW WITH YOU User Manual

BRITAX Child Safety, Inc.
In some cases, the vehicle head
restraint can prevent the child seat
head restraint from being raised high
enough to properly adjust the harness
for the fit of your child� DO NOT force
the child seat head restraint past the
vehicle head restraint� Doing so could
cause the child seat not to perform
as intended� If the location of the vehicle head restraint
interferes with the child seat head restraint, raise or remove
the vehicle head restraint� If the vehicle head restraint
cannot be removed, move the child seat to the upright
position or try a different seating location�

Overhang

Harness Mode
It is important that the base of the child seat rests
completely flat on the vehicle seat with no side overhang� As
seen in the illustration, it is permissible to allow up to 7�6 cm
(3 in�) of the base to hang over the front edge of the vehicle
seat� If the vehicle seat does not allow enough of the child
seat base to make contact, adjust the recline angle to a more
upright position� Not doing so could cause the child seat to
not perform as intended�
Booster Mode
Overhang is not allowed in booster mode� In booster mode,
the base of the child seat must fit completely on the vehicle
seat�

Adjusting Buckle Position

Removing the Buckle
1� Unbuckle the harness by
pressing the release button
and pulling the tongues�
22
WARNING!
Harness Mode
7.6 cm
Booster Mode