Table of Contents
Advertisement
To play the program
Press the > button.
To stop playing
Press the & button.
To cancel program play
Press the CONTINUE buiton, the unit enters continuous play
mode. The program will be erased.
To erase the entire program
Press the i button once during stop; twice during play.
The program is also erased when the unit is turned off.
if you press the PROGRAM button during play
The selection being played will be the first one in the
program.
To check your program
Press the CHECK button. The first selection in the program
will be displayed.
Each time you press the CHECK button, the next selection in
the program will be displayed. After the last selection, "End"
will be indicated and the display wil! soon return to the initial
status.
Or aT-Talehialemm elem aa gexe|t-1a|
You can make the following changes before starting play.
To erase the last selection, press the CLEAR button.
Each time you press the CLEAR button, the last selection in
the program will be erased.
To add a selection to the end of the program, just press
the numeric button on the remote commander for that
selection. You can also add a selection during play or pause.
To delete a selection, press the CHECK button repeatedly
until the unwanted selection is displayed. Then press the
CLEAR buiton.
To change the order, press the & button during stop to
erase the program. Then repeat the programming procedure
from the beginning.
Making a Program for Editing a Tape
You can insert a pause in your program by pressing the Il
button. Use this function to make a program for both sides of
the tape at one time.
1 Program the selections for side A
2 Press the & button.
"P" will be appear in the display and the total playing time
will be reset to 0.
3 Choose selections for side B.
When you start playing, the selections for side A will be
played and then the unit will pause with the chosen
selections for side B illuminated in the display. Set the
tape to the beginning of side B, then press the > or il
button. The selections for side B will be played.
What is the tape indicator?
During program play, the tape indicator shows you which
side of the tape the program being played is for.
ST
.
;
AQ_¢o : Side A is being played.
"aon:
Side A has been played and the unit is in pause
"——~
mode, or side B is being played.
To check the remaining time
Press the TIME button once to see the remaining time of the
selection being played; twice to see the total remaining time;
once more to return to the initial display.
If you have inserted a pause, the display shows the
remaining time until the pause.
feo; appears while checking the program for side A and also
'o03 appears while checking the program for side B.
If "--—.--" is displayed instead of the actual time
— you have programmed a selection number over 20.
— the total time has exceeded 100 minutes.
17
Advertisement
Table of Contents
