Dolmar TM-98.14 H2D Operator's Manual page 112

26
EN
engine or silencer to prevent their catching fire the next time the machine is
used!
Put the machine away in a dry, sheltered place and preferably covered with a cloth (
8.4).
IMPORTANT
and dry place. Before a long storage period (more
than 1 month), always charge the battery, and then
recharge before using again (
The next time the machine is used, check that there
are no fuel leaks from the tubes, fuel stopcock or car-
burettor.
5.4.10 Card protection device
The electronic circuit board has a self-resetting protector which breaks the circuit if
there is a fault in the electrical system. It results in the stopping of the engine and the
switching off of the lamp.
The circuit automatically resets after a few seconds but the cause of the fault should
be ascertained and dealt with to avoid reactivating the protection device.
IMPORTANT
– do not invert the leads on the battery terminals;
– do not use the machine without its battery or damage may be caused to the
charging regulator;
– be careful not to cause short-circuits.
5.4.11 Summary of main steps to follow when using the machine
To ...
Start the engine (
Go forward ( 5.4.2)
Brake or stop ( 5.4.3)
The battery must be kept in a cool
6.2.4).
To avoid activating the protection device:
5.4.1)
You will need to ...
Open the fuel stopcock, ensure that all the conditions
allowing starting are met, and then turn the key.
Apply the throttle;
Mechanical transmission: press the pedal right down,
shift into forward gear (
pedal;
Hydrostatic transmission: press the drive pedal for-
wards ( 4.32);
Reduce the engine speed and press the brake pedal.
HOW TO USE THE MACHINE
4.22) eand slowly release the
1