Dolmar TM-98.14 H2D Operator's Manual page 109

HOW TO USE THE MACHINE
5.4.4 Reverse
IMPORTANT
moving.
Mechanical transmission:
then go into reverse by shifting the lever sideways and into position «R» (
Gradually release the pedal to engage the clutch and then begin moving in reverse.
Hydrostatic transmission:
reversing by pressing the drive pedal in direction «R» (
5.4.5 Grass cutting
When you have reached the area to be
mowed, make sure that the cutting deck
wheels are positioned at the required height.
Each wheel can be fitted at two different
heights: the low position always leaves a
space between the ground and the edge of
the cutting deck to prevent the deck from
damaging the lawn if the ground is uneven.
The higher position excludes this possibility.
To change the position unscrew and remove the pin (1) then reposition the wheel (2) in
the upper and lower hole of the wale corresponding to the wheel diameter.
WARNING!
!
OFF AND THE BLADES DISENGAGED.
To start cutting:
– move the throttle to «FAST»;
– raise the cutting deck as high as possible;
– engage the blades (
– start moving forwards on the grass very slowly and with utmost caution, as already
described;
– regulate the cutting height and speed (
(the height, density and dampness of the grass).
Reverse must be engaged only when the machine has stopped
This work is to be done to both wheels, WITH THE ENGINE
4.9);
Press the pedal until the machine stops and
When the machine has stopped moving, start
4.8) considering the conditions of the lawn
4.32).
Ø 100
Ø 80
2
23
EN
4.22).
1