D-Link DGS-3130 Series Hardware Installation Manual page 51

Layer 3 stackable managed switch
Hide thumbs Also See for DGS-3130 Series:
Table of Contents

Advertisement

DGS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
To configure the terminal emulation software as follows:
Select the appropriate serial port (COM1 or COM2).
Set the data rate to 115200 baud.
Set the data format to 8 data bits, 1 stop bit, and no parity.
Set flow control to none.
To be able to view the boot procedure, the Switch needs to be rebooted. The simplest way, at this stage, to reboot the
Switch is to unplug and re-insert the power cable from and into the power receptacle on the back of the Switch.
After correctly configuring the terminal settings and re-inserting the power cable, the boot procedure will appear in the
terminal.
Boot Procedure
-------------------------------------------------------------------------------
Power On Self Test ........................................
MAC Address
: F0-7D-68-36-30-00
H/W Version
: A1
Please Wait, Loading 1.00.001 Runtime Image ...............
UART init .................................................
Starting runtime image
Device Discovery ..........................................
Configuration init ........................................
After the boot sequence has been completed, the console login screen will be displayed.
Figure 5-1 COM Port Configuration
51
V1.00.001
100 %
100 %
100 %
100 %
100 %

Advertisement

Table of Contents
loading

Table of Contents