Table of Contents
Advertisement
Troubleshooting
Problem
Suggestion
The charge/in use light
This is an indication that the battery is low, depleted, or that there is no electrical contact between
the battery and the base unit . Ensure the battery is securely plugged into the handset . Close
is flashing.
the battery compartment cover and place the handset in the base unit and let it charge until the
battery is fully charged (see page 5 . )
Common cure for
If the unit does not seem to be responding normally, then try putting the handset in its base . If it
does not seem to respond, do the following (in the order listed):
electronic equipment .
1 . Disconnect the power to the base .
2 . Disconnect the handset battery, and spare battery, if applicable .
3 . Wait a few minutes .
4 . Connect power to the base .
5 . Re-install the battery(ies) .
6 . Wait for the handset to re-establish its link with the base . To be safe, allow up to one minute
for this to take place .
www.vtechphones.com
35
Advertisement
Table of Contents
