Safety Measures - Planar 9D-12 Operation Manual

3

Safety Measures

3.1. The installation of the heater and its fittings shall be performed by authorized
organizations only.
3.2. The heater may only be used for the purposes specified herein.
3.3. The fuel supply line shall not be installed inside the passenger compartment or cabin
of a motor vehicle.
3.4. The vehicle electric harness shall not be installed near the fuel supply line.
3.5. A vehicle that uses the heater shall be equipped with a fire extinguisher.
3.6. It is prohibited to use the pre-heater in areas, where highly inflammable vapors or
ample quantity of dust may be generated or accumulated.
3.7. To prevent the possibility of exhaust gas poisoning, the heater shall not be used when
the vehicle is in the closed, not aired rooms (garage, workshop, etc).
3.8. When refueling the vehicle, the heater shall be switched off.
3.9. When performing welding operations on the vehicle or repairs on the heater,
disconnect the heater from the vehicle battery.
3.10. When assembling or dismantling the heater, observe the safety measures specified by
electric work regulations for the fuel supply system and the vehicle's wiring system.
3.11. The heater shall not be connected to the vehicle electric circuit while the engine is
running or the battery is switched off.
3.12. The heater's electric power supply must not be disconnected before the end of
the purge cycle.
3.13. The heater is powered from the accumulator battery regardless of the availability of
the vehicle frame connection.
3.14. The heater's connectors must not be connected or disconnected while the heater's
electric power supply is turned on.
3.15. It is forbidden to step on a heater and to put on it subjects.
3.16. It is forbidden to cover a heater with articles of clothing, pieces of fabric, etc. and as
to place them before its entrance or an exit of heated air.
3.17. Wait 5 to 10 seconds before switching the heater back on.
3.18. In the event of two subsequent ignition failures, contact the maintenance department
to report a malfunction.
3.19. In the event of a failure in heater operation, contact a designated repair organization
authorized by the manufacturer.
3.20. Manufacturer warranty shall not apply if the above requirements are not adequately
met.
4