Connecting Basic Cable Directly To The Tv; Using Your Cable Box Connections - Vizio L15 User Manual

2.4.2 – Connecting Basic Cable Directly to the TV
Installation:
1. Turn off the power to the LCD TV.
2. Connect the Cable TV signal to the TV
jack on the LCD TV Monitor. Screw it
down tight.
3. Turn on the power to the LCD TV.
4. Select "AIR" using the Video Source
button on the remote control. Select
"TV" using the Audio Source button on the remote control.
Note:
a) Make sure the antenna is correctly grounded.
b) See Section 3.4.2.1 – TV Install page 20 for selecting the TV source within the
OSD menus (cable or air (antenna)).

2.4.3 - Using Your Cable Box Connections

2.4.3.1 - Cable Box with RF In/Out Jacks
Note: This connection will not supply Stereo sound to the LCD TV Monitor. The sound from the
Cable Box will be monaural (single-channel, not left and right).
Installation:
1. Turn off the power to the LCD TV.
2. Connect the Cable TV signal to the IN jack
(i.e., "RF IN" or "CABLE IN") on the Cable
Box.
3. Connect the RF coaxial cable to the OUT jack
(i.e., "TO TV" or "RF OUT") of the Cable Box.
4. Connect the other end of the coaxial cable to
the LCD TV Monitor's TV jack. Screw it down tightly.
5. Turn on the power to the LCD TV.
6. Set the Channel 3 or 4 (or Output channel) switch of the Cable Box to 3 or 4.
7. Set the TV to the same channel. When watching TV programming, change channels at
the Cable Box, not the LCD TV Monitor.
Version - 4/5/2005 15
www.vizioce.com
VIZIO L15 User Guide