Charging The Battery - Vivitar Vivicam 5105s User Manual

Charging the Battery

Using the AC power adapter may charge the battery or operate the ViviCam 5105s as power supply. Make sure
that the power of the ViviCam 5105s is off and then insert the battery before starting.
1. Insert one end of the AC power adapter into the DC IN terminal of the ViviCam 5105s.
2. Insert the other end of the AC power adapter into a wall outlet.
The status LED flashes green when charging is started and lights green when charging is completed.
It is recommended to fully discharge or exhaust the battery before being charged.
Charging time varies according to the ambient temperature and the status of battery.
Note:
This ViviCam 5105s must be used with specified AC power adapter. Damage caused by the use of an
incorrect adapter is not covered under the warranty.
When the charging is not started even if following the above procedure, turn the power on at any mode after
LCD monitor turns on, and then turn the power off.
The battery may feel warm after it has been charged or immediately after being used. This is normal and not
a malfunction.
When using the ViviCam 5105s in cold areas, keep the ViviCam 5105s and battery warm by holding them
inside your outer cloth.
If you open the battery cover without removing the battery, the power will not be terminated. If you remove
the battery, you have to insert the battery again in a period of 2 hours in order to make sure that the date
and time will not be reset.
We recommend the battery should be charged 8 hours as first time use.
20