Panasonic SA-HT920P Service Manual page 26

Player Remote control
buttons unit buttons
0
5
6
7
STOP
DISPLAY
3
PAUSE
10
12.3 DVD Self Diagnostic Function-Error Code
Error
Code
U, H error
U11 Focus error
H01 Tray loading error
H02 Spindle servo error
H03 Traverse servo error
H04 Tracking servo error
H05 Seek error
H06 Power error
H07 Spindle motor drive error
DSC related
F500 DSC error
F501 DSC not Ready
F502 DSC Time out error
F503 DSC communication Failure
F504 Error adjusting DSC data slice offset
F505 DSC Attention error
F506 Invalid media
ODC related
Access failure to management information
F600
caused by demodulation error
F601 Indeterminate sector ID requested
Access failure to LEAD-IN caused by
F602
demodulation error
Access failure to KEYDET caused by
F603
demodulation error
F610 ODC abnormality
F611 6626 QCODE don't read Error
F612 No CRC OK for a specific time
F620 Laser safeguard: high temperature condition
F621 Laser safeguard: circuit failure condition
F630 No reply to KEY DET enquiry
CPPM KEY DET is not available till the FILE
F631
terminal
F632 CPPM KEY DET is not available
Error code display
Tilt adjustment
Area number and broadcasting system check
Built-in program version check
DVD laser drive current check
CD laser drive current check
Writing of laser drive current value after replacement of
optical pickup (Do use this function only when optical
pickup is replaced.)
Initialization of the player (factory setting is restored.)
Used after replacement of micro-computer and its
peripherals and printed circuit board.
Error Content
Application
(Spindle servo, DSC (IC3001) SP motor, CLV servo error)
Cannot switch off the power because of the panel and
system computer communication error
DSC (IC3001) stops in the occurrence of servo error (starup,
focus error, etc.)
DSC-system computer communication error (Communication
failure caused by idling of DSC)
Similar disposal as F500
Communication error (result error occurred although
communication command was sent)
Similar disposal as F500
Disc is flipped over, TOC unreadable, incompatible disc
Operation stopped because navigation data is not accessible
caused by the demodulation defect
Operation stopped caused by the request to access
abnormal ID data
LEAD IN data unreadable
Access failure to CSS data of disc
No permission for command execution
Access failure to seek address in CD series
Access failure to ID data in DVD series
(for internal use only)
(CPPM file system is unreadable caused by scratches)
Been revoked or falsified
(Refer to the item, "12.3.
Self Diagnostic Function-Error
Code ").
Refer to the item "15.4. Optical
adjustment").
Refer to the item "12.1.
Pickup Breakdown Diagnosis
Additional error explanation
Note
DVD
Optical
".