Panasonic TX-1703MA Series Operating Instructions Manual page 6

Signal Connection
The signal connector should be connected as follows according to the type of signal connector
and the signaling system used.
A. When the Signal Connector is 15 Pin Mini D-Sub (In the Case of PS/2 or compatible)
Connect the signal cable to the 15 pin mini D-sub connector of the display unit.
Push the signa! connector select switch upwards.
B. When the Signal Connector is a 15 pin D-Sub Connector (In the case of MAC-II)
Convert the 15 pin D-sub connector of the MAC-II to a 15 pin mini D-sub connector using a con-
version connector, and then connect it to the 15 pin mini D-sub connector of the display unit.
Push the signal connector select switch upwards.
Check if the change-over connector is connected as shown in the following figure.
15 中
Pin Arrangement of 15 Pin
Mini D-Sub Connector
Red video signal
Green video signal
mS
5 | Space No connection |
e — ] Ground for reg video signal |
8 [ Ground tor blue video signal —
CSR
14 Verialsevonzmgspna —
Space No connection
Pin Arrangement of 15 pin
D-Sub Connector
Pinno [Signal Gomector |
G>
3
c =]
ce.
o^ e = oO eo 3
e
= ED Kal = 23 €» = = ©
= D
2
to
2
CH
2
に 3
7
10
11
13
14
5
1
C. When the Signal Connector is BNC Connector Signal Systems
Push the signal connector select switch downwards.
Signal connector select switch
€ Separate System
Connect the signa! cables to RED, GREEN,
| | | | BLUE, H-SYNC AND V-SYNC connectors.
e
En. 2. e
Composite System
Connect the signa! cable to RED, GREEN, BLUE
and H-SYNC (H/V composite) connectors.
Sync On Green System
Connect the signal cable to RED, GREEN (sync
on green) and BLUE BNC connectors.
— 4 —