Panasonic TX-1703MA Series Operating Instructions Manual page 10

2-1. Registration Procedure
1. Input the signal of the computer which you are going to use into the display unit.
2. Adjust the size and position of the image using the control buttons.
3. Press the memory button. (Registration completed)
Precautions:
Moire may appear due to timing mode being selected. In such a case, please mini-
mize the level of the moire by changing the amplitude (either of horizontal or
vertical).
2-2. Storage Allocation of Data
The state of the storage area of user mode Press the momory button.
e When open space is availabel Data are registered in the open space.
e if the timing storage allocation is full The oldest data will be deleted.The new date is re-
gistered in the open space created by the deletion.
e If the timing you want to save is already registe- | When the memory button is pressed, new data are
red in the user's timing storage area. overwritten on the already registered data and regis-
tered simultaneously.
e if you want to change size and position of a fac- | Adjust the size and position, then push the memory
tory.
butlon. This will update the Factory Preset.
Note:
O If the difference between any of the factory preset timings and the user's timing is smaller than the allow-
able deviation, and the polarity of their synchronizing signals are the same, then they are considered to
be the same timing and the user's timing will not be registered.
O Factory preset timing data can be altered by adjusting the size and position of the picture, but the timing
cannot be deleted.
The following table is to record the timing for users.
Polarity of synchronizing Display area
signal
Vertical
frequency
Vertical
size
Horizontal Vertical Horizontal
synchronization | synchronization size
Display image | Horizontal
Data segment | element