Note On Scv Connection - Grundig WKC 4870 RDS A Manual

~ Adjust the basic volume during a traffic
flash (TP in the display G6).
The control is accessible through an open-
ing in the cabinet cover using a small
screwdriver (see fig.).
Adjusting the
SCV range
Adjusting the
traffic flash volume 4
louder softer
CS Sa
i Soa ae. =
3) SCV connection
~ The way the unit is connected is dependent
on the type of vehicle.
Information about this can be obtained
from your dealer; see also "Note on SCV
connection".
Note on SCV connection
The SCV requires a speed-dependent signal
which is already present on cars fitted with an
electronic speedometer, computer, automatic
speed control, etc.
Normally, this signal can be picked up at the rear
of the speedometer. If your car is not yet equip-
ped with an impulse generator, it is possible in
most cases to additionally fit such a generator.
To find out whether your vehicle is suitable for the
SCV connection, consult your dealer.
Your unit is suited for the connection of all types
of impulse generators.
The SCV should be connected with the SCV lead
supplied. If your vehicle has already been fitted
with an impulse generator, and this is electrically -
éonnected to chassis, you will only have to inter-
connect the signal-carrying lead with the SCV
connection.
Important
If the vehicle is is provided with an impulse
generator and this is used for other functions, en-
sure that the signal carrying impulse generator
lead is not short-circuited against the vehicle
chassis when making the SCV connection.
95