Bajaj pulsar F250 Owner's Manual page 17

DETAILS - AFE1, TRIP1 / AFE2, TRIP2
Procedure to set AFE1 & TRIP1:
Ignition switch is ON & Set push button pressed for
less than 1 sec. - TRIP1 mode gets selected &
following display will be shown by digital speedometer
1. AFE1 (Average Fuel economy1): This will indicate
the average fuel economy in km/L in TRIP1 mode.
2. TRIP1: The Trip meter shows the total distance
that the vehicle has travelled in TRIP1 mode. If
TRIP1 is reset, average fuel economy (AFE1) will
reset.
Note: AFE will be updated every 60 sec. AFE will be reset if corresponding TRIP1 or TRIP 2 is reset or battery disconnected.
1 2
Procedure to set AFE2 & TRIP2:
Ignition switch is ON & Set push button pressed for
less than 1 sec. - TRIP2 mode gets selected &
following display will be shown by digital speedometer
3. AFE2 (Average Fuel economy2): This will indicate
the average fuel economy in km/L. in TRIP2 mode.
4. TRIP2: The Trip meter shows the total distance that
the vehicle has travelled in TRIP2 mode. If TRIP2 is
reset, average fuel economy (AFE2) will reset.
13
3 4