Bajaj pulsar F250 Owner's Manual page 41

Sr. NO.
Activities/Check Points
General lubrication – Clutch lever /
33
Rear brake pedal
34
Tyre air pressure.
Mirror position & joint rmness.
35
All fasteners tightness, few are
36
1. Front & rear axle
2. Swing arm axle
3. Engine foundation
4.Rider / Pillion foot rest holder
(Stay)
37
Mobile USB port
Drain hole no blockage verication
38
below starter motor
Fuel tank water drain no blockage
39
verication
Recommended frequency - Service interval & Kms
1st 2nd 3rd 4th
500~ 4500~ 9500~ 14500~
750 5000 10000 15000
C,L C,L C,L C,L
C,A
C,A C,A C,A
C,A C,A C,A C,A
C,T C,T C,T C,T
C,R C,R C,R C,R
C,CL C,CL
C,CL
C,CL C,CL
C,CL
37
5th 6th 7th
19500~ 24500~ 29500~
20000 25000 30000
Use recommnded AP grease.
C,L C,L C,L
Front - 1.75 Kgf/cm2 (25PSI)
Rear (Solo)- 2 Kgf / cm2(28PSI)
C,A C,A C,A
Rear (Pillon)-2.25Kgf/cm2 (32 PSI)
C,A C,A C,A
Recommended Torque Values
Front & Near axle:8 to 10Kgf-m
Swing arm axle-13 to 15 Kgf-m
Engine foundation-
C,T
C,T C,T
Front top : 2.8 to 3 Kgf-m
Front bottom : 4 to 4.2 Kgf-m
Rear : 4 to 4.2Kgf-m
Rider/Pillon foot reast holder - 1.8
to 2.2 Kgf-m
Charging OK to be Checked at Engine
C,R C,R
C,R
start condition using LED USB light
C,CL
C,CL C,CL
C,CL C,CL C,CL
Remarks