Disassembly Procedure - Mitsubishi Electric Mr. SLIM SLZ-M15FA2.TH Technical & Service Manual

11

DISASSEMBLY PROCEDURE

SLZ-M15FA2.TH SLZ-M25FA2.TH
SLZ-M15FA2-ER.TH SLZ-M25FA2-ER.TH
SLZ-M15FA2-ET.TH SLZ-M25FA2-ET.TH
OPERATING PROCEDURE
1. Removing the air intake grille and air filter
(1) Slide the knob of air intake grille to the direction of the
arrow 1 to open the air intake grille.
(2) Remove the grille hook from the panel to prevent the
grille from dropping.
(3) Slide the hinge of the intake grille to the direction of
the arrow 2 and remove the air filter.
2. Removing the panel
(1) Remove the air intake grille. (Refer to procedure 1)
Connector box (See Photo 1)
(2) Remove the screw of the connector cover.
(3) Slide the connector cover to the direction of the arrow to
open the cover.
(4) Disconnect all the connectors, then pull out the connec-
tors that are coming from panel side from the connector
box.
Corner panel (See Figure 2 and Photo 2)
(5) Loosen the screw from the corner of the corner panel.
(6) Slide the corner panel as indicated by the arrow.
(7) Remove the safety strap from the hook, then remove the
corner panel from the panel.
(The safety strap is not equipped for the signal receiver
panel and i-see Sensor corner panel.)
(8) Remove the fastener (*), then remove the corner panel.
Panel (See Photo 3)
(9) Remove the 4 screws.
(10) Unlatch the 2 hooks.
* Fastener is only for the signal receiver and i-see Sensor cor-
ner panel.
TCH067A
SLZ-M35FA2.TH SLZ-M50FA2.TH
SLZ-M35FA2-ER.TH SLZ-M50FA2-ER.TH
SLZ-M35FA2-ET.TH SLZ-M50FA2-ET.TH
Figure 1
Air intake grille
1
Air intake grille knobs
Photo 1
Connector box
Fastener*
Figure 2
Photo 2
Safety strap
Photo 3
Hook
31 31
SLZ-M60FA.2TH
SLZ-M60FA2-ER.TH
SLZ-M60FA2-ET.TH
Be careful when removing heavy parts.
PHOTOS/FIGURES
Grille hook
1
2
Grille
Screw
Connector cover
Screw
Corner panel
Hook
Screws
Screws
Air filter
Fastener*
Grille
Turbo fan
Nut and
washer for
turbo fan
Hook