Troubleshooting - DeLonghi ECAM35075 Manual

18. TROUBLESHOOTING

Some possible malfunctions are listed below.
If the problem cannot be resolved as described, contact customer services.
PROBLEM
The coffee is not hot.
The coffee is weak or not
creamy enough.
The coffee is delivered too
slowly or a drop at a time.
The appliance will not make
coffee
Coffee does not come out of
one or both spouts.
The appliance does not come
on
At the end of descaling, the
appliance requests a third
rinse
POSSIBLE CAUSE
The cups were not preheated.
The internal circuits of the appliance have
cooled down because 2/3 minutes have
elapsed since the last coffee was made.
Coffee temperature setting too low.
The coffee is ground too coarsely.
The coffee is unsuitable.
The coffee is ground too finely.
The appliance has detected impurities in its
internal circuits. "Please wait" is displayed.
The coffee spouts (A9) are blocked.
It is not plugged into the mains socket.
The main switch (A22) is not turned on.
During the two rinse cycles, the water tank has
not been filled to the MAX level.
REMEDY
Warm the cups by rinsing them with hot
water (Please note: you can use the hot water
function).
Before making coffee, rinse the internal circuits
by pressing the
Set a higher coffee temperature in the menu.
Please note! Varying the temperature has most
effect for long drinks.
Turn the grinding adjustment dial (A5) one
click anticlockwise towards 1 while the coffee
grinder is in operation (fig. 7). Continue one
click at a time until coffee delivery is satisfac-
tory. The effect is only visible after delivering
2 coffees (see section "8.1 Adjusting the coffee
grinder"r").
Use coffee for espresso machines.
Turn the grinding adjustment dial (A5) one
click clockwise towards "7" while the coffee
grinder is in operation (fig. 7). Continue one
click at a time until coffee delivery is satisfac-
tory. The effect is only visible after delivering
2 coffees (see section "8.1 Adjusting the coffee
grinder"r").
Wait for the appliance to be ready again and
reselect the required drink. Contact customer
services if the problem persists.
Clean the spouts with a toothpick (fig. 26B).
Plug into the mains socket (fig. 1).
Place the main switch in the I position (fig. 2).
Follow the instructions displayed by the appli-
ance, but first empty the drip tray to avoid the
water overflowing.
24
button (B5).
→