Table of Contents
Advertisement
3.
Remove the battery (see
Remove the speakers:
1.
Left speaker: Disconnect the speaker cable (1) from the system board.
2.
Remove the two Phillips M1.6 × 2.5 screws (3) that secure the speaker.
3.
Remove the speaker from the computer (3).
NOTE:
When removing the speaker, make note of the location of the two rubber isolators (4). The
absence of or damage to these isolators can result in degraded speaker performance.
4.
Right speaker: (Models with 4-zone keyboard lighting) Disconnect the backlight cable (1) from the
system board.
5.
Remove the two Phillips M1.6 × 2.5 screws (2) that secure the speaker.
6.
Lift the speaker (3) up.
7.
Use needle-nose pliers to disconnect the speaker cable (4) from the bottom of the system board.
NOTE:
When removing the speaker, make note of the location of the two rubber isolators (5). The
absence of or damage to these isolators can result in degraded speaker performance.
Battery on page
31).
Speakers
39
Advertisement
Table of Contents
