Table of Contents
Advertisement
NOTE:
The display assembly is spared at the subcomponent level. For display assembly spare part
information, see the individual removal subsections.
Before removing the display panel, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the display assembly:
1.
Remove the two Phillips M2.5 × 3.0 screws (1) and the Phillips M1.0 × 1.2 screw (2) from each display
hinge.
2.
Open the display (3) to 90°.
3.
Separate the display from the computer while guiding the cables through the holes (4) in the top
cover.
4.
To remove the display panel:
a.
The display panel is secured to the display enclosure with tape that is installed under the left
and right sides of the panel. The top of the panel is secured to the rear cover only with hooks.
To remove the panel, use a tool (1) to pry the top of the panel away from the top of the display
rear cover.
b.
Use tweezers to grasp the end of the tape on both sides of the panel (2). While turning the
tweezers (3), wrap the tape around the tweezers as you continue to pull the tape out (4) from
behind the display panel. You must pull the tape multiple times before it is completely removed.
Display panel tape is available in the Adhesive Panel Kit as spare part number N84332-001.
50
Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
30).
Battery on page
31).
30).
Advertisement
Table of Contents
