Chain Tensioner) - Stihl MS 210 Instruction Manual

English
1
3
1
2
Fit the guide bar over the studs (1) –
N
the cutting edges on the top of the
bar must point to the right.
Engage the peg of the tensioner
N
slide in the locating hole (2) –- place
the chain over the sprocket (3) at
the same time.
Turn the tensioning screw (4)
N
clockwise until there is very little
chain sag on the underside of the
bar – and the drive link tangs are
engaged in the bar groove.
Refit the sprocket cover and screw
N
on the nut only fingertight.
Go to chapter on "Tensioning the
N
Saw Chain"
26
Mounting the Bar and Chain
(quick chain tensioner)
Removing the chain sprocket cover
4
Swing grip (1) into position (until it
N
engages)
Turn the wing nut (2) to the left until
N
it hangs loosely in the chain
sprocket cover (3)
Remove chain sprocket cover (3)
N
Mounting the tensioning gear
Remove and reverse tensioning
N
gear (1)
1
3
2
1
MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
2
Remove screw (2)
N
1
Position tensioning gear (1) and
N
guide bar (3) relative to one another
2
Insert and tighten screw (2)
N
3