Stihl MS 210 Instruction Manual page 51

Replacing the Starter Rope
Models with ElastoStart
10
Pry the cap (10) out of the grip.
N
Remove the remaining rope from
N
the rotor and starter grip.
Thread the new rope through the
N
starter grip and tie a simple
overhand knot. Dimension "a"
should be about 0.16 in (4 mm) to
0.23 in (7 mm).
Pull the knot back into the grip.
N
Refit the cap in the grip.
N
MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
11
Thread the end of the rope
through the top of the guide
N
bushing (11) and rope rotor (12)
and secure it with a simple
a
overhand knot.
Go to "Installing the Rope Rotor".
N
Models without ElastoStart and models
with Easy2Start
12
Remove the remaining rope from
N
the rotor and starter grip.
Thread the new starter rope through
N
the rotor and secure it with a simple
overhand knot.
Thread the other end of the rope
N
through the rope guide bushing
(from inside) and the underside of
the starter grip and secure it with
one of the special knots shown – do
not wind the rope onto the rotor.
English
49