Program Dry Operation - Daikin RXYMQ3AV4A Operation Manual

Program DRY Operation

Program DRY is a function that alternates between weak cooling and stopping the unit to remove humidity from
the air, in order to prevent the room temperature from dropping and becoming too cold.
• The microcomputer automatically controls the temperature and fan strength, so these cannot be set using the remote
controller.
• This function is not available if the room temperature is 16°C or lower.
FOR SYSTEMS WITHOUT COOL/HEAT CHANGEOVER REMOTE CONTROLLER
1.
Press OPERATION MODE SELECTOR button several times and select "
2.
Press ON/OFF button.
OPERATION lamp lights up and system starts OPERATION.
FOR SYSTEMS WITH COOL/HEAT CHANGEOVER REMOTE CONTROLLER (Only for the heat pump)
1.
Select cooling operation mode with the cool/heat changeover remote controller.
2.
Press OPERATION MODE SELECTOR button several times and select "
3.
Press ON/OFF button.
OPERATION lamp lights up and system starts OPERATION.
Adjustment
4.
Press AIR FLOW DIRECTION ADJUST button.
Refer to page 11 for details.
STOPPING THE SYSTEM
5.
Press ON/OFF button again.
OPERATION lamp goes off, and the system stops OPERATION.
ATTENTION:
• Do not turn OFF power immediately after the unit stops. Then, wait on no less than 5 minutes. Water is leaking or there
is something else wrong with the unit.
BRC1C62
TEST
1
1
(only for FXCQ, FXFQ, FXHQ, FXAQ)
2·5
1
4
" (PROGRAM DRY Operation).
BRC1C62
3-5
4
2
" (PROGRAM DRY Operation).
10