Table of Contents
Advertisement
OPERATION
Program Dry Operation
Program dry is a function that alternates between weak cooling and stopping the unit to remove humidity from
the air, in order to prevent the room temperature from dropping and becoming too cold.
• The microcomputer automatically controls the temperature and fan strength, so these cannot be set using the remote
controller.
• This function is not available if the room temperature is 16°C or lower.
1. Press mode selector button several times and select " " (Program Dry Operation).
2. Press ON/OFF button.
Operation lamp lights up and system starts operation.
ADJUSTMENT
3. Press airflow setting button. (only for FXCQ, FXFQ, FXHQ, FXAQ)
Refer to page 10 for details.
STOPPING THE SYSTEM
4. Press ON/OFF button again.
Operation lamp goes off, and the system stops operation.
ATTENTION:
• Do not turn off power immediately after the unit stops. Then, wait on no less than 5 minutes. Water is leaking or there is
something else wrong with the unit.
9
BRC1E62
2,4
Advertisement
Table of Contents
