Table of Contents
Advertisement
INSTRUCTIONS FOR USE
1. Your massagers, when opened, may require charging. To charge your
massagers, plug one
side
of the USB-C cords into each unit and plug the other
ends into an adapter.
Your
massager will be fully charged after a maximum of
5 hours charge time, and the charge will last up to 2 hours. NOTE: This device
only comes with
a
USB-C cord, not an adapter. A USB-C charger will also
charge the units. The units will not operate when charging. Use a 5V/2A
(or
5V/1A, slower) charger, but
can
not be higher than 5V.
2.
Look at the
"R"
or
"L"
tags at the top of each unit, and place each unit around
the corresponding calf. The control box should be aligned on the outside of the
leg. Please see image below.
3. Use the velcro to adjust the straps to the size of your
legs.
4. Press the power button to turn on the unit. The display will illuminate to confirm
the unit is on.
5. Press the
"MODE"
button to select between the
4
massage modes. Press the
"HEAT"
button to toggle between 3 levels of heat. Press the
"INTENSITY"
button to adjust the intensity of the air compression.
6. The unit will turn off automatically after 15 minutes.
CAUTION: To avoid injury, always remain seated when using massager.
5
Advertisement
Table of Contents
