Preset Adjustment Of The Picture Level Control Knobs - Control Preset Adj Menu; Overview; Setting Lists In The Control Preset Adj Menu - Sony HD Trinitron HDM-20E1J Operation Manual

Preset Adjustment of the Picture Level Control
Knobs — CONTROL PRESET ADJ Menu

Overview

The preliminary adjustment of contrast, brightness and
chroma are carried out with the CONTROL PRESET
ADJ menu to set the preset values to the knobs for the
above-mentioned adjustments. Preset values can be set
either commonly to all channels or separately for
individual channels.
Structure of the CONTROL PRESET ADJ Menu
Level 1 Level 2
PRESET [A1] MANUAL [A11]
CH SET [A2] AUTO [A12]
COPY [A13]
The lower levels of CH SET are the same as ones of PRESET.

Setting Lists in the CONTROL PRESET ADJ Menu

This section explains the setting lists displayed in the
menu.
How to read the setting lists
• For purposes of explanation, each setting list is
preceded by a menu number. These numbers are not
displayed on the screen.
For more information about the menu number, see "About
menu numbers" on page 15 (E).
• The arrow mark (÷) refers you to another setting list
that appears after you make the setting, or to an
operation that is carried out as a result of the setting.
When there is no arrow mark, the menu does not have
any sub-list.
[A] CONTROL PRESET ADJ menu
Select either PRESET or CH SET. ÷[A1]
PRESET: Set common values.
CH SET: Set values for each individual channel.
Preset values can be set in the following ways:
• Adjustment with the MANUAL knobs
• Automatic adjustment (An external color bar signal is
• Copying data from other channels, common data,
Level 3
FULL FIELD 8CB 100
FULL FIELD 7CB 100 PRESET
OTHER VALUE [A131]
CH SET
OTHER MONITOR [A132] MONITOR ADDRESS [A1321]
MEMORY CARD [A133]
FILE NAME[A1331]
[A1] PRESET menu/CH SET menu
Select the setting method.
MANUAL: Set with the MANUAL knobs. ÷[A11]
AUTO: Set by automatic adjustment. ÷[A12]
COPY: Copy data from elsewhere. ÷[A13]
[A11] MANUAL menu
Adjust values by turning the CHROMA, BRIGHT,
and/or CONTRAST knobs. After the adjustment, press
the ENTER button to confirm the adjusted values.
CHROMA: xxxx
BRIGHT: xxxx
CONTRAST: xxxx
When you want to erase characters from the screen
while adjusting manually
Press the [F1] button. The characters disappear. To
display characters, press the [F1] button again.
To reset the setting to the default
Press the corresponding MANUAL button. The
adjusted value is reset to 1000 (default).
necessary.)
other HDM-series monitors that have been connected
via the serial remote connector, or from data stored in
monitor memory cards
[A]
Level 4 Level 5
PRESET
CH SET
PRESET
CH SET
21 (E)