Preset Adjustment Of The Picture Level Control Knobs - Control Preset Adj Menu; Overview; Structure Of The Control Preset Adj Menu [A]; Setting Lists In The Control Preset Adj Menu - Sony Trinitron BVM-20G1U Operation Manual

Preset Adjustment of the Picture Level Control
Knobs — CONTROL PRESET ADJ Menu

Overview

The preliminary adjustment of contrast, brightness,
chroma, and phase are carried out with the CONTROL
PRESET ADJ menu to set the preset values to the
knobs for the above-mentioned adjustments.
Structure of the CONTROL PRESET ADJ Menu
Level 1 Level 2
MANUAL [A1]
FULL FIELD CB 100
AUTO [A2]
FF CB 75 (WHITE 100)
SMPTE CB
EIA CB
COPY [A3] OTHER MONITOR [A31]
MEMORY CARD [A32]

Setting Lists in the CONTROL PRESET ADJ Menu

This section explains the setting lists displayed in the
menu.
How to read the setting lists
• For purposes of explanation, each setting list is
preceded by a menu number. These numbers are not
displayed on the screen.
For more information about the menu number, see "About
menu numbers" on page 19.
• The arrow mark (÷) refers you to another setting list
that appears after you make the setting, or to an
operation that is carried out as a result of the setting.
When there is no arrow mark, the menu does not have
any sub-list.
[A] CONTROL PRESET ADJ menu
Select the setting method.
MANUAL: Set with the MANUAL knobs. ÷[A1]
AUTO: Set by automatic adjustment. ÷[A2]
COPY: Copy data from elsewhere. ÷[A3]
Preset values can be set in the following ways:
• Adjustment with the MANUAL knobs
• Automatic adjustment (An external color bar signal is
necessary.)
• Copying data from other BVM-series monitors that
have been connected via the serial remote connector,
or from data stored in monitor memory cards.
[A]
[A1] MANUAL menu
Adjust values by turning the CHROMA, BRIGHT,
CONTRAST and/or PHASE knobs. After the
adjustment, press the ENTER button to confirm the
adjusted values.
PHASE: xxxx
CHROMA: xxxx
BRIGHT: xxxx
CONTRAST: xxxx
When you want to erase characters from the screen
while adjusting manually
Press the [F1] button. The characters disappear. To
display characters, press the [F1] button again.
To reset the setting to the default
Press the corresponding MANUAL button. The
adjusted value is reset to 1000 (default).
25