Table of Contents
Advertisement
FS-SD5R/FS-SD7R/FS-SD9R
mMRemoving
the
CD
mechanism
base
assembly (See Fig.6 to 13)
- Prior to performing the following procedure, remove
the rear cover, the side covers and the front panel
assembly.
—_
. Remove the four screws E attaching the CD door on
the upper side of the body.
. Disconnect the card wire from connector CN104 and
CN105
of the main
board
in the front part of the
body. Disconnect the card wire from CN101
of the
main board on the right side, and the harness from
CN705
and CN708
of the CD
mechanism
base
assembly respectively.
iw)
3. Remove
the four screws
F_
attaching
the CD
mechanism base assembly on the upper side of the
body.
Remove
the screw
|
attaching
the earth
terminal on the right side.
4. Remove the screw G attaching the heat sink board
on the back of the body. Disconnect the harness
from connector CN301
and pull the heat sink board
fully outward.
CD mechanism base assembly
Heat sink board
CN301
2-2
CD door
Fig.6
CD mechanism base assembly
"\
Fig.7
CD mechanism base assembly
Main bard
ON
CN101
Fig.8
CD mechanism base assembly
Fig.9
Advertisement
Table of Contents
