Sharp BE-2520 Service Manual page 20

pulsory duplicate.
— For compulsory duplicate, depress [2] key
— For non-compulsory duplicate, depress [4] key
Depress validation function key
*
Input Validation
code function key
* DEPOSIT, CASH OUT, CASH IN, CASH
CHECK, MISC1, MISC2, MISC3, MISC4.
Return the mode switch to the "REG" position.
3-6. (MRS6) Changing of TAB and zero suppres-
sion symbol
® Turn power OFF.
@ Set mode switch to "2" mode.
@ Depress and hold the [5] and keys
@ Turn power on
-- Make sure the display i is filled with zeros
@ Release keys
e
Input a two digit code for the following
— ist entry ditit
Validation print zero suppression
symbol (printed in the highest place)
@ Depress the |ACCT #]| key
@ Return the mode switch to the "REG" position.
3-7. (MRS7) Preset teller and/or machine number
@ Turn power OFF.
@ Set mode switch to "Z" position
@ Depress and hold down the [6] and [CASH OUT] keys
@ Turn power on -
— Make sure display shows all zeroes.
@
Input a4 digit code (According to the following chart)
for the application desired.
BE=2520
Set code
T/No
1XXxX
Application :
In PGM mode, teller No. (in3 digits),
can be set arbitrarily. :
The upper 1 digit i is fixed as frase
No.; the lower 2 digits. can be. .
arbitrarily set as teller No. in PGM
mode.
M/No. T/No.
2 (X) XX
The upper 2 digits are fixed as
machine No.; the lower 1 digit can be
arbitrarily set as teller No. in PGM
M/No. T/No.
3 (X X) X-
mode.
4 re) The 3 digits are fixed as machine No.
@ Depress the |ACCT #] key
@ Return mode switch to REG position.
3-8. (MRS8) Single or double cycle printing
Single cycle printing:
Using pressure-sensitive
paper
as the journal
paper, the
operation is completed
by one printing of validation into
the slip.
Double cycle printing:
Using ordinary paper as the journal paper, the same infor-
mation is printed into the journal automatically by pulling
out the slip after printing the validation into the slip.
(This is effective only when the light sensor is built in.)
@ Turn power OFF.
@ Set mode switch to "Z" position.
© Depress and hold the [7] and
keys
@ Turn power on.
— Make sure display shows all zeroes
@ Release keys
@
Input a one digit code (using the following chart) for the
desired application.
Set code Application
1 One cycle printing
Double cycle printing
Code entry
(1 digit) — .
© Depress the |ACCT # | key:
@ Return mode switch to "REG" position
@ Turn power OFF.
Turn mode switch to "'Z" position
Depress and hold down the iB}e and 4 [TOTAL] keys
Turn power on
-- Make-sure display shows all zeroes::
Release keys : uf
Return.mode switch to "REG". soutien
@ Turn power OFF.
@ Set the mode switch to "Z" position.
© While pressing the numeral key [9] and [SUB-TOTAL
key at the same time, turn on the power switch.