Advertisement
• Place the collector in its housing by screwing it in completely to ensure it is watertight but do not overtighten it.
• Put the tab back in place.
• The next time you use the generator hold down the «OK» button for a few seconds to turn off the orange light.
In addition to this regular maintenance, it is advisable to rinse the boiler tank out completely every 6 months or after
approximately 25 uses, whichever is the sooner.
• Check that the steam generator is cold and has been unplugged for at least 2 hours.
• Place the steam generator on the edge of your sink and stand the iron upright.
• Remove the collector cap and unscrew the Anti-calc collector and remove it from the base unit.
• Hold your steam generator in an inclined position. Use a jug to fill the boiler tank with 1/4 litre of untreated tap
water.
Shake the base unit gently for a few seconds and then empty it completely into the sink.
• Place the collector in its housing by screwing it in completely to ensure it is watertight.
• Put the tab back in place.
Next time you use your appliance, press the «OK» button located below the control panel until the orange
«Anti-Calc» light goes out.
«AUTO-OFF» System
• For your safety, the steam generator is fitted with an «AUTO-OFF» monitoring system, which is activated automatically
after approximately 8 minutes without use.
• Only the «ON-OFF» button flashes to indicate that the appliance is on standby.
• To reactivate the steam generator:
- Press the «ON-OFF» button.
- Wait for the «ON-OFF» button light to stop flashing before starting your ironing again.
• For your safety, after approximately 30 minutes of non-use, the «AUTO-OFF» system switches off your steam
generator. To start your ironing again, press the «ON-OFF» button.
Storing the steam generator
• Place the iron on the steam generator iron rest.
• Switch your steam generator off by pressing the «ON-OFF» button and unplug the appliance.
• Raise the locking system over the iron until the protection system locks into place (audible click)
• Store the steam cord in its slide storage place. Take it, fold it in two so as to make a loop. Put the end of this loop in the
sliding storage then push gently until you see the end on the other side of the sliding storage
• Press the power cord storage button - to store the power cord in its housing. (depending on model)
• Leave the steam generator to cool before putting it away if you are storing it in a cupboard or a confined space.
• If you store your steam generator in a relatively cold place (approximately <10C°), put it in a warm place before
starting your ironing.
• You can store your steam generator safely by carrying it by the iron handle
Environment protection first!
i Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
Advertisement
