5. Remove 3 screws and then remove A-Board.
9.7.
Removal of DN-Board
1. Remove Duct Barrier K.
2. Disconnect the connectors (DN1, DN4, DN5, DN8).
3. Remove the flexible cables from the connectors (DN10,
DN16).
4. Remove 4 screws and then remove DN-Board.
Note:
A re-setup of the destination is performed by MS
mode after DN-Board exchange.
9.8.
Removal of PB-Board
1. Disconnect the connectors (PB30, PB31, PB53, PB54,
PB59, PB61, PB62, PB67, PB69, PB71).
2. Remove 4 screws and then remove PB-Board.
9.9.
Removal of D-Board
Check that no bright points appears by Ve Life adjustment
after both A and D board exchange.
27
TH-103VX200W