TH-50VX100U / TH-50VX100E
8.8.
Removal of DN-Board
1. Disconnect the connectors (DN3, DN5, DN9, PB31,
PB32, PB33, PB34, PB35, PB38).
2. Remove the flexible cables from the connectors (DN1,
DN2).
3. Remove 4 screws and then remove the DN-Board Block.
4. Remove 2 screws ( ) and then remove the PB-Board
Block.
5. Remove 2 screws ( ) and then remove DN-Board.
Note:
A re-setup of the destination is performed by MS
mode after DN-Board exchange.
8.9.
Removal of D-Board
1. Remove the Slot Block.
(Refer to Removal of Slot Block)
2. Disconnect the connectors (D3, D5, D25).
3. Remove the flexible cables from the connectors (D20,
D31, D32, D33).
4. Remove 4 screws and then remove D-Board.
8.10. Removal of P-Board
1. Disconnect the connectors (P2, P6, P7 P9, P11, P12,
P25).
2. Remove 12 screws and then remove P-Board (MAIN)
with Fixed Plate and P-Board (AC).
8.11. Removal of H3-Board (L), (R)
1. Remove 2 screws and then remove the Speaker Terminal
Block (L), (R).
2. Disconnect the connector (H37).
3. Remove 6 screws (G) and then remove the H3-Board.
22