Using The Projector; Control Buttons - ViewSonic LiteBird PJ853 User Manual

Using The Projector

The control buttons display menus that are explained in detail in the section: "OnView Indicators" on
page 8.

Control Buttons

Press a control button to display a menu then use the arrow buttons to adjust the control. The buttons
on the projector control pad and on the remote control are explained below:
Standby/on Button
Press the STANDBY/ON button to begin the warm-up period. The ON indicator
blinks green during warm-up and stays green when the projector is ready to use.
NOTE: The projector cannot be restarted within 60 seconds after it is turned off because
the projector enters a cool-down mode. This is a safety feature.
Input Button (Video and RGB Buttons)
The INPUT button shown is on the projector only. Use the Video and RGB buttons on
the remote control to select the input source.
Press the Input button on the projector to toggle between input sources, computer
(RGB), Composite or S-Video. The remote control has both a Video and an RGB
button.
- Press RGB to select a computer as the input source.
Press Video to toggle between Composite and S-Video.
-
Projector control pad
Figure 7: Projector and Remote Controls
Remote control
ViewSonic PJ853
E
N
G
L
I
S
H
6