Installation Steps - ViewSonic LiteBird PJ853 User Manual

Installation Steps

Verify Input/Output Connections
1
Make sure that you have properly connected all input cables before powering on the projector.
2 Remove the lens cap.
Power on the Projector.
3
Turn on the Main Power Switch located on the side of the projector. The power indicator will
•
remain a steady orange. See "Using The Projector" on page 6.
Press (and hold for 1 second) the Standby/ON button on the projector control pad.
4
The power indicator flashes green during warm-up.
•
The power indicator will remain a steady green after warm-up. The steady green light indicates
•
that the ViewSonic PJ853 is ready to use.
To shut off the lamp – Press the Standby/ON button (and hold for about 3 seconds). The unit
•
will remain in cool-down mode with the fan on and the orange power LED blinking for 1
minute. The power switch on the side of the projector may be turned off after 1 minute, when
the power light is a steady orange.
Position the Projector
5
Make sure that the projector is properly positioned on a level and stable surface. Determine the
distance the projector will be from the screen then adjust the angle of the projection by
positioning the foot adjusters. (See "Adjusting the Projector Angle on page" 5.)
Power on Input Devices
6
Press either the Input button on the projector control pad or the Video/RGB button on the
•
remote control to select the signal to be projected.
The selected input signal source displays in the lower right section of the screen.
•
Adjust the Focus
7
Turn the lens ring to adjust the focus
Caution: The projector requires a warm-up period after the power is turned on, and the projector
requires a cool-down period after the power is turned off.
The power cannot be turned on for at least 1 minute after the unit has been powered off; this
NOTE:
is a safety feature.
Notebook Computer
Desktop Computer
Figure 4: System Setup
Video recorder with S jack
(Note: S-video cable not included)
Video recorder
ViewSonic PJ853
E
N
G
L
I
S
H
4