Regency ULTIMATE U41FS-NG Installation And Operating Instructions Manual page 9

INSTALLATION
Log Stand Installation
a) Loosen the 4 screws in the top of the rear
burner.
b) Slide the two rear log support brackets into
position as shown in the diagram.
c) Push the rear log support brackets tight
against the screws and then tighten down the
Rear Log
screws.
.Screws
Back
Rear Log
Support
Burner
Push bracket forward until
it is tight against the screws,
then tighten screws.
Top View
2) Remove the logs from the heater and carefully
unwrap them. The logs are fragile, handle with
care • DO NOT FORCE into position.
3) Place embers along full length of the front burner
tray. Put embers on top of the front burner but
keep embers clear of the pilot and make sure
the embers do not prevent the front log from
sitting properly on the front log stands. Do not put
any embers in the rear ember tray. Use only about
half of the embers in the package. Keep the
remaining embers for use after annual mainte¬
nance of cleaning the inside firebox.
See Maintenance on page 15.
Rear Log Cross Log Rear Log
Supports^ / Rear Log Support
Rear
fesilli
Ember
Front Log
Embers J§|
Front
J
/ Front Log 1 Rear Log
Ember Front Support Rear Support
Tray Burner Burner
Diagram 2: Side View
4) Carefully place the rear log (with no cutouts) so it
rests on the rear supports (with the flat part of the
log to the back) and then push the log flush
against the back. Center the log, relative to the
rear burner. The knot in the log should sit just to
the right of center. See diagrams 1 & 2.
5)
Place the front log (with the cutouts) on the two
front log supports, the log must be even with the
front edge of the supports. See diagrams
1
&
2
.
6) The cross logs must be positioned on the
front and rear logs as shown in diagram 3.
Incorrectly positioned cross logs will affect the
flame pattern and proper operation of the unit.
Use the two top holes in the front log for position¬
ing. The insideedge of the left log is even with
the left edge of the hole and the "thumb" just
touches the front edge of the hole. The inside
edge of the right log is even with the right edge of
the hole and the "thumb" is centered above the
knot in the rear log.
Front Loj
Support
my
Rear
-Burner
Front Log
"Support
Front
Ember
Tray
Embers / Front'Log Burner
Diagram 1: Top View
Regency ULTIMATE Freestanding Gas Heater
Diagram 3: Top View