(2)
Cut off the inner cable covers
of the iris control
cable as shown in the diagram.
Approximately 6 mm
Put the heat shrinkable tubes or equivalent tubes on
the inner cables of the iris control cable.
Solder the inner cables of the iris control cable at
the pin-plug block according to the following pin
assignment and cover the heat shrinkable tubes or
equivalent tubes at soldered area and the heat on
the tubes to shrink.
Pin 1: Power source; +6V DC, 50mA Max.
Pin 2: Not used
Pin 3: Video signal; 0.7Vp-p/40 kohms
Pin 4: Shield, ground
(When the Lens Selection Switch (7) is set to the
VIDEO position)
Pin 3
Pin 1
-16-
Both the connector cover and connector should be
positioned to interlock.
Connector
cover
| Automatic
<
iris lens
a\K
Heat
shrinkable
Iris control
tubes
cable
~ Connector
Note:
Cut off the rib on the connector, when the iris
control cable is thick and the connector
cover
and connector can not locked.