Assigning M/E Reentry Input Signals To Cross-Point Buttons; Assigning Output Signals; Setting Monitor Outputs - Sony MVS-3000A System Startup Manual

Assigning M/E Reentry Input Signals
to Cross-Point Buttons
A video signal created on one bank can be used as the input
signal on another bank, for example, an image created on
the M/E-1 bank can be used as the background on the
PGM/PST bank. These signals are referred to as "M/E
reentry input" signals.
On the ICP-3000/3016, to select an M/E reentry input
signal, the signal must be assigned to a cross-point button
beforehand.
This section describes the procedure for setting the M/E-1
reentry input.
On the ICP-6520/6530, this setting is not required as
signals can be assigned using the reentry buttons on the
control panel.
1
Display the menu.
a Open the Engineering Setup >Panel >Xpt Assign
menu (7322).
b Press [Main, V/K Pair Assign].
The Main, V/K Pair Assign menu (7322.5) appears.
2
Assign an M/E-1 reentry signal to a cross-point button.
V/K
Video Key
Main, V/K Pair Assign menu
a In the [V/K] column of the list on the left, select the
number of the cross-point button.
Select the button number to which you want to
assign the M/E-1 reentry input signal.
b In the <Assign> group, press [Video] and [Key],
turning them on.
Turn on both [Video] and [Key].
c In the list on the right, select "M/E1OUT1".
d In the <Xpt Assign> group, press [Set].
The M/E-1 reentry input signal is assigned.
24

Assigning Output Signals

Set
Assigning Output Signals
You can set the signals output to the connected devices on
the OUTPUTS of the switcher processor.

Setting Monitor Outputs

This section describes the procedure for setting up
monitors for checking final program output video
(program output) and for checking preview video (preview
output).
1
Display the menu.
a Open the Engineering Setup >Switcher >Output
menu (7333).
b Press [Output Assign].
The Output Assign menu (7333.1) appears.
2
Set a monitor for program output.
Out#
Re-Entry Source
Output Assign menu
a In the <Output Assign> group, select [Re-Entry
Source].
b In the [Out#] column in the list on the left, select the
number for the OUTPUTS connector connected to
the monitor.
In this example, select "1".
c In the [Src#] column in the list on the right, select
the program output.
In this example, select "P/P PGM1".
d Press [Set].
The output signal is assigned, and "P/P PGM1" is
displayed for output 1 in the [Out#] column.
Src#
Set