Table of Contents
Advertisement
Administrator Information
Items
Remote
Authentication Method
ID Type
ID
Pre-Shared Key
Confirm Pre-Shared
Key
❏ Encapsulation
If you select IPsec for Access Control, you need to configure an encapsulation mode.
Items
Transport Mode
Tunnel Mode
❏ Security Protocol
If you select IPsec for Access Control, select an option.
Items
ESP
AH
>
Advanced Security Settings
Settings and Explanation
To select Certificate, you need to obtain and import a CA-signed certificate in
advance.
If you select Pre-Shared Key for Authentication Method, select the type of
ID for the device that you want to authenticate.
Enter the printer's ID that matches to the type of ID.
You cannot use "@", "#", and "=" for the first character.
Distinguished Name : Enter 1 to 255 1-byte ASCII (0x20 to 0x7E) characters.
You need to include "=".
IP Address : Enter IPv4 or IPv6 format.
FQDN : Enter a combination of between 1 and 255 characters using A-Z, a-z,
0-9, "-", and period (.).
Email Address : Enter 1 to 255 1-byte ASCII (0x20 to 0x7E) characters. You
need to include "@".
Key ID : Enter 1 to 255 1-byte ASCII (0x20 to 0x7E) characters.
If you select Pre-Shared Key for Authentication Method, enter a pre-shared
key between 1 and 127 characters.
Enter the key you configured for confirmation.
Settings and Explanation
If you only use the printer on the same LAN, select this. IP packets of layer 4 or later are
encrypted.
If you use the printer on the Internet-capable network such as IPsec-VPN, select this
option. The header and data of the IP packets are encrypted.
Remote Gateway(Tunnel Mode): If you select Tunnel Mode for Encapsulation, enter a
gateway address between 1 and 39 characters.
Settings and Explanation
Select this to ensure the integrity of an authentication and data, and encrypt data.
Select this to ensure the integrity of an authentication and data. Even if encrypting data is
prohibited, you can use IPsec.
443
>
Encrypted Communication Using IPsec/IP Filtering
Advertisement
Table of Contents
