Initial Setup and Assembly
TX231RW Multi-Sensor
1. Install 3 AA batteries into the bottom of the Multi-sensor.
2. The red LED light on the bottom, will flash every 30 seconds
when transmitting.
Drain Vents
for Rain
3. Insert pole into the bottom of sensor and secure with two screws.
Note: Your own mounting pole (1.2 inches, 3.1 cm, not included)
may be inserted into the sensor, instead of using the
mounting bracket and pole included.
Page | 3
Wind Cups
Solar Panel
Red LED
A
A
A
A
A
A
www.lacrossetechnology.com/support
Direction Vane
Mounting
Bracket
Bubble Level
for Mounting
Rain
Gauge
Pole
328-2314